Monday, April 13, 2009

Toroid & "finished" coil


This is the sideways view... maybe I should rotate it... of the "completed" primary, and secondary coil. Along with the toroid. The toroid is just aluminum ducting around two pie plates (again, thanks grandma Nina). The top wire of the secondary goes to the toroid (the discharge terminal) while the bottom goes to RF ground (IE a stake in the earth). The primary is not physically connected to the secondary (with electrically conductive material) anywhere, only magnetically.

Primary coil


This is the primary coil through which current from our NST and MMC flows. The NST builds up current in the MMC (multi mini capacitors), which is a bunch of capacitors wired together to form one big one, until it has enough power. Once it has enough power to arc the spark gap (not shown) it will rush through that and the primary coil, and create the magnetic field necessary to induce the current in the secondary coil. We had issues winding this too, which I think I described in an earlier post... This is just .25 inch copper refrigerating piping, using 20 ft.

Secondary


The finished secondary coil. We wound in groups of fifty, using a quick actionscript program I rigged up to keep track of the windings. Every fifty, we would stop and hit a key fifty times to add on to our ongoing count. Using this setup, it only took about an hour.

This is our setup for spinning the secondary coil. The secondary is what the current is magnetically induced in from the primary, so we needed 930 turns of magnet wire around this. You can see the drill, gear reducer, and PVC form, but there are things you CAN'T see. The magnet wire we bought, had a kink in the spool, so we wound a few coils around it, and then it wouldnt budge. We nipped the wire, and wound it ALL (like 600 feet) around that orange spool in the picture, so we did two windings.

Oh Crap

Well it turns out, we were supposed to varnish the secondary coil before winding. Whoops. I guess we'll see what happens when you don't...

Sources

I guess I should list our coil sources.

www.deepfriedneon.com helped A LOT with all of the parts.
TeslaMap, www.teslamap.com (a multiplatform java program) helped with calculations for the MMC and other things
Home Depot, basically all the parts except the MMC, and the NST
My friend for the NST which, I don't know if it will even work
And my father, and grandfather for help on building it :D

Anything else I think of, I'll add later.

Kind of done...

We took a 2x24 inch pvc pipe for our secondary coil. After hooking up a drill to it, to spin to wrap NINE HUNDRED AND THIRTY turns of our 24 AWG magnet wire around it, we had a problem. The drill went MUCH to fast for this sort of thing, even on low. We found a gear reducer, and then had no problem spending an hour on this. Our primary is copper tubing wrapped like 7 times, so to do this we got this PVC wood stuff (haha oxymoron) and cut it into 9.5 inch long sections. Using a drill press, a bunch of holes were drilled in .75 inches apart, for the tubing. After screwing around with putting the tubing on, we finally cut the section in half, laid the tubing in, and screwed the top half to the bottom half. Much easier. The toroid was made with aluminum ducting, and two pie plates (Thank you grandma Nina!). We riveted (I learned something new) the pie plates together, and then just hot glued the aluminum around them in a donut shape. Now looking for capacitors...