Monday, April 13, 2009

Kind of done...

We took a 2x24 inch pvc pipe for our secondary coil. After hooking up a drill to it, to spin to wrap NINE HUNDRED AND THIRTY turns of our 24 AWG magnet wire around it, we had a problem. The drill went MUCH to fast for this sort of thing, even on low. We found a gear reducer, and then had no problem spending an hour on this. Our primary is copper tubing wrapped like 7 times, so to do this we got this PVC wood stuff (haha oxymoron) and cut it into 9.5 inch long sections. Using a drill press, a bunch of holes were drilled in .75 inches apart, for the tubing. After screwing around with putting the tubing on, we finally cut the section in half, laid the tubing in, and screwed the top half to the bottom half. Much easier. The toroid was made with aluminum ducting, and two pie plates (Thank you grandma Nina!). We riveted (I learned something new) the pie plates together, and then just hot glued the aluminum around them in a donut shape. Now looking for capacitors...

No comments:

Post a Comment